[netatalk-admins] natatalk on eth0 and not eth1

Subject: [netatalk-admins] natatalk on eth0 and not eth1
From: Simon Buchanan (simon@newmedia.net.nz)
Date: Mon Apr 19 1999 - 02:17:30 EDT

• Next message: Simon Buchanan: "[netatalk-admins] Dual Ethernet Card Setup"
• Previous message: Mike Holling: "[netatalk-admins] netatalk and Retrospect"
• Next in thread: thomas: "Re: [netatalk-admins] natatalk on eth0 and not eth1"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Hi,

I have a standard install of netatalk-14.b2+asun2.1.3-2 on redhat5.2... two
ethernet cards eth0 (192.168.1.1) and eth1 (internet), could someone give me
some directions to set atalk over ip for eth0 only?

at the moment, afpd.conf is:

"server" -notcp

and atalkd.conf is:

eth0 -phase 2 -net 0-65534 -addr 65280.181

but netatalk set this by it self after i just put "eth0" in.

and when i try to bring /etc/rc.d/init.d/atalk up it spits this back at me:

#Usage aftp [-..... blablabla.

Anyone>?

--
Simon Buchanan
Systems Administrator
New Media Communications
===================================================
simon@newmedia.net.nz           www.newmedia.net.nz

• Next message: Simon Buchanan: "[netatalk-admins] Dual Ethernet Card Setup"
• Previous message: Mike Holling: "[netatalk-admins] netatalk and Retrospect"
• Next in thread: thomas: "Re: [netatalk-admins] natatalk on eth0 and not eth1"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b28 : Sat Dec 18 1999 - 16:16:36 EST